Tuning overhangs - Bambu Studio - Bambu Lab Community Forum

I’m trying to understand how to tune overhangs for my Polymaker ASA filament. I had dialed the fan speed way down to promote layer adhesion, except for overhangs. But overhangs came out shitty: I had: 0% fan @ 35s 20% fan @ 5s 100% fan for overhangs I then adopted the bambu ASA fan settings (leaving everything else the same): 25% @ 35s 90% @ 3s 80% for overhangs The result is much better: Notice that the bad model has 100% fan for overhangs and the good one only 80%. So is less fan

Print Quality Issue, Overhangs, X1 Carbon, PLA - Bambu Studio - Bambu Lab Community Forum

Overhang Issues - General discussions - Bambu Lab Community Forum

Bambu Lab A1 Review: Full Size Bed Slinger

Tuning overhangs - Bambu Studio - Bambu Lab Community Forum

Print Quality Issue, Overhangs, X1 Carbon, PLA - Bambu Studio - Bambu Lab Community Forum

Tuning overhangs - Bambu Studio - Bambu Lab Community Forum

Tuning overhangs - Bambu Studio - Bambu Lab Community Forum

Print Quality Issue, Overhangs, X1 Carbon, PLA - Bambu Studio - Bambu Lab Community Forum

Help with overhangs : r/BambuLab

Slow Down for Overhangs

Bambu Lab X1 Carbon Review: Living In The Future

Support Bambu Lab Wiki

Tuning overhangs - Bambu Studio - Bambu Lab Community Forum

Tuning overhangs - Bambu Studio - Bambu Lab Community Forum