Hotend pauses on print for a few seconds after finish printing

Any one know how to change settings/gcod so that the hotend does not pause on the top layer after it finish printing? This leaves a dimple where it paused. Thanks!

Creality Hot End Repair and Parts Guide for Ender 3, CR-10, and other Creality 3D printers — Creality Experts

marlin - Hot end temperature varies during print - 3D Printing Stack Exchange

Leaking hotend - multiple prints fail after about two hours, shorter prints are ok. Before this print I cleaned the hot end and it was spotless, put in a new steel nozzle

Quality Prints at High Speed: With PowerBoost 2.0 technology and Ultra Direct Extruder, AnkerMake M5C can achieve printing speeds of up to 500 mm/s

AnkerMake M5C 3D Printer, 500 mm/s High-Speed Printing, All-Metal Hotend, Supports 300℃ Printing, Control via Multi-Device, Intuitive, 7×7

Troubleshooting Guide to 19 Common 3D Printing Problems

Advanced guide to printing PETG Filament

Features:, 〠Precise Auto leveling】GEEETECH Mizar S is only printer with dual-leveling system, which enables one-button ABL automatic bed leveling

Geeetech Mizar S 3D Printer with Auto-Leveling Printing Platform Fixed Heat Bed Dual Z- and Gear Extruder 255x255x260mm Print Size for 1.75mm Filament

Simplify 3D® Software MakerGear - MakerGear™

Professional desktop 3D Printer from CreatBot F430

Random Printing Paused with Filament Sensor Reloaded - Plugins - OctoPrint Community Forum

Printer pausing 1-3 sec every ~10 print moves

Pauses in 3D printing: inserts and color changes

Raise3D E2 3D Printer

Filament extrusion always stops at some point during print - 3D Printing Stack Exchange

Making Your 3D Printer Pause or Wait with G-Code in Marlin - 3D Print Gorilla