Print starts before bed - General Discussion - Klipper

After latest machine upgrade, I “tweaked” the printer.cfg and the Cura settings too many times to remember all the changes I made, and now, when I slice in Cura, the model appears at the middle of the bed, but when I start the print, it starts BEFORE the bed on the Y axis (X position is centered)…Is it Cura or Klipper related?

Print starts before bed - General Discussion - Klipper

Klipper, the Recore, and OctoPrint

Bad Top Layers when printing large surface – Assembly and first prints troubleshooting – Prusa3D Forum

Some general settings.? - General Discussion - Klipper

How to Use Cura Slicer with Klipper 3D Printer Firmware

Prints with bed mesh applied much worse than without it. · Issue #3007 · Klipper3d/klipper · GitHub

Klipper Mesh settings (Voron 2.4r1.5) & poor prints with new extruder stepper - General Discussion - Team FDM

How to make bed hold temp before printing? : r/klippers

Am I using mesh leveling wrong? – General discussion, announcements and releases – Prusa3D Forum

Bed mesh makes first layer worse - General Discussion - Klipper

Ender 3 v2 with dual z, klipper, and bmg 2.0 extruder. Having issues with uneven layers. The layers at the top and bottom of the “x” and “y” are bulged out. This

Klipper Bed Mesh - General Discussion - Team FDM